RouterOS beta • Re: MikroTik OpenVPN Features
Does anybody know, if MikroTik is going to include in the OpenVPN the TLSv.13?Statistics: Posted by netfox — Thu Dec 28, 2023 7:03 pm
View ArticleScripting • Re: cookie based auth using fetch
actually if I pass output=user-with-headers I see the cookie info. Now I just need to parse out the cookie and pass it. Anyone done this before?Statistics: Posted by snowdogging — Thu Dec 28, 2023...
View ArticleGeneral • Policy based routing
Hi,In RouterOS 7.6, I would like to setup a route, which would catch all reply packets RELATED to connection coming from a given interface wg1 and route such packets via wg1 rather than the default...
View ArticleGeneral • Re: Policy based routing
Almost there. You need to limit the route marking rule, because this one applies also to incoming packets. As a result, they will be sent back, because route marks have maximum priority in ROS. Either...
View ArticleAnnouncements • Re: v7.12.1 [stable] is released!
damm I really made a fool of myself :( I upgraded my CCR1036-12G to V7.12.1 I was otherwise running V 6.49. It runs as VPN Server and it just doesn't work anymore :( Upload is now only max 2 Mbit and...
View ArticleWireless Networking • Transparently bridge two lans using wifi?
I am looking for something similar to Transparently Bridge two Networks using MPLS using a hAP ax^3 running 7.13 as the AP and a Raspberry Pi 2 Model B with an Archer T3U USB WiFi adapter running...
View ArticleWireless Networking • Re: Configuring hAP ax2 with CapsMan
Thank you. I've located and am beginning to understand this new layout. This NEW CapsMan is both similar AND different from the old one. I've spent a few hours figuring things out, and the Mikrotik...
View ArticleWireless Networking • Re: Transparently bridge two lans using wifi?
No way.Or write your driver.Statistics: Posted by Ca6ko — Thu Dec 28, 2023 8:34 pm
View ArticleGeneral • Re: mikrotik with PPPoe and real ip behind bridge modem
Good evening all,I did not understand the architecture that is provided by Ogero for such services. Isn’t it possible to be just as simple as normal router configuration instead of bridge mode. I...
View ArticleGeneral • Re: BGP peer goes down, no ACK for 60 minutes
The fact that this is the only response I get says a lot about Mikrotik.This is a user forum.. Mostly users here.. There are a few employees here but not many..Have you tried upgrading firmware? Why...
View ArticleWireless Networking • Re: CAPax 2 SSIDS on 2 VLANs + 1MGT VLAN > I'm...
Since you have an explicit forward accept rule for list "lfwd" followed by drop on forward, possibly this part ? The missing interfaces ?Code: /interface list memberadd interface=e2 list=lmgtadd...
View ArticleWireless Networking • Re: running old and (wifi) capsman on the same device
You need base routeros (which now default carries wave2 wifi drivers) and wireless package installed on the device acting as controller for legacy and wave2 caps.On that device you will loose local...
View ArticleRouterBOARD hardware • Re: Usage GPON module SFP in Spain
I have EPON ISP. They white listed MAC of my RB5009 SFP port. They can see it on their side. I'm using DFP-34X-2C2 and link is Ok. I can access web UI, telnet etc. I even receive network settings over...
View ArticleContainers • Re: need iptables in a container
I described a similar problem here. According to the support, iptables is currently unavailable for third-party code. But they may eventually allow it. Please submit a ticket via the support...
View ArticleBeginner Basics • Re: hap ax^2 config
There are two distinct wireless driver packs: legacy "wireless" which supports older wirrless chipsets up to and including ac. And the new wifi (wifi-qcom and wifi-qcom-ac) which supports newer...
View ArticleGeneral • Re: "failure: AEAD already provides authentication"
I've seen this question a few times already. Per the interwebs:AES-GCM (Galois Counter Mode) internally uses AES in CTR mode that can provide confidentiality and at most Ind-CPA security. AES-GCM also...
View ArticleForwarding Protocols • Re: two networks
What you assume about a bridge is probably wrong.Read the documentation on what a bridge is and does.You only need one bridge and add all interfaces to it.Then configure the interfaces, VLANs,...
View ArticleAnnouncements • Re: v7.14beta [testing] is released!
What's new in 7.14beta4 (2023-Dec-29 10:05):*) system - expose "lo" and "vrf" interfaces;good. now please make VRF import/export (local inter-VRF route leaking) finally work (...
View ArticleGeneral • How to block ip scanners
hello all i searched the forum for similar topic and i didn't find a solution yet for this i made the following :bridge - use ip firewall wireless AP- uncheck default forward for all APfirewall - make...
View ArticleGeneral • Re: external hardisk on CHR - remote access
ROS is not NAS OS, it's routing OS with some added services. Which usually aren't very well implemented and thus at least problematic when one wants to use them for anything except for ROS management...
View Article