Wireless Networking • Re: Netbox 5 AX, L11UG-5HaxD wont send data
viewtopic.php?t=205097&start=300#p1066230Code: What's new in 7.14.2 (2024-Mar-27 09:48):*) wifi-qcom - added configuration.distance setting to enable operation over multi-kilometer distances (CLI...
View ArticleGeneral • Re: Bandwidth usage per IP
Thank you for your work, it works perfect.When I try to save the report to a shared drive (runs on SMB raspberrypi) using :local reportpath...
View ArticleRouterOS beta • Re: dhcp-server matcher filter
*bump* Really need this feature - would be great to have a wildcard matcher. Any news on this?Statistics: Posted by cmcawood — Wed Mar 27, 2024 4:20 pm
View ArticleRouterBOARD hardware • Outdoor 5G?
Hi.Is there any rumors regarding a WAP 5G or something else I can use to get 5G connectivity in a boat? I need to have the antennas outdoor/in the top of the mast (15meters+), so a POE solution is a...
View ArticleWireless Networking • Re: NetMetal5 to NetMetal AC² problem
We can't upload wifi-qcom or wifiwave2.npk packages into the device, cause there's no free disk space (NetMetal AC² has a total of 16mb and the running firmware and wireless package already uses...
View ArticleRouterBOARD hardware • Re: Outdoor 5G?
Something like this (though not being a rumor)?https://mikrotik.com/product/netbox_5_axDo you require 802.11ax or is 802.11 ac sufficient?Any other requirements?Statistics: Posted by erlinden — Wed...
View ArticleGeneral • Re: Multicast across switches does not work (CRS3xx)
SUP-144274 is created on February 19th, no response ever since "waiting for support".I updated the ticket that the problem is exactly the same on ROS 7.14.1.Statistics: Posted by subway — Wed Mar 27,...
View ArticleGeneral • Re: Configure mulitple DHCP Server on each ethernet port
Hi,Thank you for your reply.As I can see, you advise me to use VLAN whatever happens.I understand the principle of a VLAN and also the fact that it can be broadcast through devices such as the CAP AX...
View ArticleBeginner Basics • Ethernet-connected devices keep disconnecting and reconnecting
My RB5009 logs have started to get filled with "disconnected, connection lost" followed by "connected, signal strength -XX" wrt MikroTik cAP ax access points that are connected via ethernet to the...
View ArticleGeneral • Re: NAT 1:1 on Mikrotik - without gateway on the client device
These NAT rules should be fine.If you can set up routes on "WAN" side and PLC address space doesn't clash with addresses on WAN side, then you could set route (dst 192.168.0.0/24 gateway 10.40.100.X...
View ArticleGeneral • Memory leak for cap AC 7.14 running wifi-qcom-ac?
I've seen this now a couple of times, both with 7.14 and 7.14.1:Screenshot 2024-03-27 at 18.52.51.pngBasically reboot the cap AC, and watch its memory slowly but inexorably go down. Once it's above...
View ArticleGeneral • Re: Memory leak for cap AC 7.14 running wifi-qcom-ac?
7.13.5, cap ac, wifi-qcom-ac, uptime 1week. free memory: 32.6mbStatistics: Posted by infabo — Wed Mar 27, 2024 8:00 pm
View ArticleRouterOS beta • Re: Routing filter to discard routes
Hi guys,I'm running a lab (eve-ng) to proof the "input.accept-nlri" parameter. I've configured "input.accept-nlri=!filtered" in "/routing/bgp/connection" hierarchy, because even with the rule matching...
View ArticleClik here to view.
Wireless Networking • Re: Problems with Capsman on RB5009 and CAP 5HaxD2HaxD...
Hi, Finally I made it work, I guess because I did many many changes lately I had a few errors in the VLAN80 so it was not working indeed... but now I Got it working, so for somebody struggling when...
View ArticleGeneral • Re: LICENCE
yes i have reached 500 pppoe limit, i want to buy license 6 from mikrotik, wanted confirmation that RB5009UPr can take level 6 license.Statistics: Posted by mogiretony — Thu Mar 28, 2024 12:48 pm
View ArticleRouterBOARD hardware • hAP ax3 temperature at 58-60 degrees...
Greetings. Tell me, MikroTik hAP ax3, is the temperature at 58-60 degrees normal at work? CPU usage ranges from 5 to 35%. There are no special loads and rules. I am grateful in advance.Statistics:...
View ArticleBeginner Basics • Re: Basic VLAN Access Port
I've been able to set up a DHCP server for the VLAN. I can connect to the router on eth5, and I get an address, but that's where the fun stops. You currently have:Code: /interface bridge portadd...
View ArticleRouterBOARD hardware • Re: hAP ax3 temperature at 58-60 degrees...
yes, it is normalStatistics: Posted by normis — Thu Mar 28, 2024 12:55 pm
View ArticleGeneral • Re: Wireguard from MT to client (win10) with several users to...
And also routes for each VLAN?Statistics: Posted by korg — Thu Mar 28, 2024 12:59 pm
View ArticleScripting • Scritp for Black list for failed login to IPSec VPN
Dear colleagues,I've been suffering lately from many connectivity attempts via IPSEC and as a result, the logs of the Mikrotik equipment I manage are full of entries and information.The events I...
View Article
