General • Re: Load balancer via ECMP or PCC on 2 starlinks

Hello again,
So... I set up the VRF and had the next trouble with load balancer.


/ip vrf
add interfaces=ether2 name=Groupe-2-Route
add interfaces=ether1 name=Groupe-1-Route

/ip address
add address=192.168.1.254 interface=ether1 network=192.168.1.1
add address=192.168.1.254 interface=ether2 network=192.168.1.1

/ip firewall nat
add action=src-nat chain=srcnat out-interface=ether1 to-addresses=\
192.168.1.254
add action=src-nat chain=srcnat out-interface=ether2 to-addresses=\
192.168.1.254

/ip route
add distance=1 dst-address=0.0.0.0/0 gateway=192.168.1.1@Groupe-1-Route routing-table=\
main
add distance=2 dst-address=0.0.0.0/0 gateway=192.168.1.1@Groupe-2-Route routing-table=\
main

add dst-address=192.168.5.0/24 gateway=LAN10 routing-table=Groupe-1-Route
add dst-address=192.168.5.0/24 gateway=LAN10 routing-table=Groupe-2-Route

add dst-address=192.168.2.0/24 gateway=LAN20 routing-table=Groupe-1-Route
add dst-address=192.168.2.0/24 gateway=LAN20 routing-table=Groupe-2-Route

add dst-address=192.168.3.0/24 gateway=LAN30 routing-table=Groupe-1-Route
add dst-address=192.168.3.0/24 gateway=LAN30 routing-table=Groupe-2-Route



/ip firewall mangle
add dst-address=!192.168.0.0/24 src-address=192.168.0.0/24 action=mark-routing chain=prerouting new-routing-mark=Groupe-1-Route nth=2,1
add dst-address=!192.168.0.0/24 src-address=192.168.0.0/24 action=mark-routing chain=prerouting new-routing-mark=Groupe-2-Route nth=2,2

/ip route
add distance=1 gateway=10.10.10.10 routing-mark=Groupe-1-Route check-gateway=ping
add distance=1 gateway=11.11.11.11 routing-mark=Groupe-2-Route check-gateway=ping

add distance=2 gateway=11.11.11.11 routing-mark=Groupe-1-Route
add distance=2 gateway=10.10.10.10 routing-mark=Groupe-2-Route

Statistics: Posted by mihail — Thu Feb 08, 2024 9:36 am

---