Anyone?
when appying the script i was unable to get any access to the device.
Needed to reset the whole config.
Shouldn't be this difficult to create the setup I need?
All other vendors I used in the past supported this setup, and was not hard to build.
Please advise.
recap what I need.
eth 1 = wan DHCP
eth 2-5 bridge, native netword (vlan1) - (so no vlan when connecting a device to one of the ports) and vlan 10 with packets that have a vlan set. This is for the accesspoints attached that have 2 SSID's. One on the default vlan, nothing special here, and one with VLAN10 set. This is for guests.
Best,
Leon
when appying the script i was unable to get any access to the device.
Needed to reset the whole config.
Shouldn't be this difficult to create the setup I need?
All other vendors I used in the past supported this setup, and was not hard to build.
Please advise.
recap what I need.
eth 1 = wan DHCP
eth 2-5 bridge, native netword (vlan1) - (so no vlan when connecting a device to one of the ports) and vlan 10 with packets that have a vlan set. This is for the accesspoints attached that have 2 SSID's. One on the default vlan, nothing special here, and one with VLAN10 set. This is for guests.
Best,
Leon
Statistics: Posted by lblokland — Thu Dec 28, 2023 5:23 pm