General • [Discussion] MikroTik configuration abstraction complexity
This is my first forum post, that I am making in genuinely trying to get MikroTik to see pain points of most MikroTik users, especially SOHO/Home users and even professional network engineers...
View ArticleGeneral • Re: hAP Lite LTE6 LTE Modem upgrade fails
Hi, I have a similar problem. New router launched, next updated to 7.13.3 and then I get a message about the new modem firmware.It doesn't work - update fails - "Couldn't start - firmware URL not...
View ArticleBeginner Basics • Re: VLAN tagged/untagged on same router
Just a small tip: do not turn on VLAN filtering until you've configured everything else because you may lose access to the routerStatistics: Posted by TheCat12 — Thu Feb 01, 2024 9:42 pm
View ArticleGeneral • Re: Trying to use VLANs & L3 HW offload
Would be great to hear your results using CRS309 with 8Gbps ISP together with L3HW nat.I had tried before with 1Gbps (DHCP) provider and worked fine, until I got a new provider which required PPPoe...
View ArticleWireless Networking • Re: 5GHz channels disappeared on hAP ax2
Update on this issue... recall that my router is now configured with 5500, 5180 in the frequency box. At 10:20 this morning, radar was detected on 5500. Let's put aside why a radar event was detected...
View ArticleGeneral • Re: [Discussion] MikroTik configuration abstraction complexity
Some latest examples of the issue with abstraction complexity:viewtopic.php?t=203326viewtopic.php?t=204009viewtopic.php?t=203981viewtopic.php?t=143510Statistics: Posted by DarkNate — Thu Feb 01, 2024...
View ArticleClik here to view.
Beginner Basics • Re: need help with choosing right hardware stack for a home...
... see if Audience is acceptable ... but no idea how well they work.My audience, running 7.13.2 and wifi-qcom-ac, runs excellently. Just tested with recent smart phone: it connects with 866Mbps rate...
View ArticleGeneral • Re: ARTICLE: Multipoint VPN with ZeroTier and MikroTik
Here is part 2 where I go over scaling the design using Regions.https://lev-0.com/2024/02/01/multipoint ... al-design/Statistics: Posted by L0crian — Thu Feb 01, 2024 10:13 pm
View ArticleBeginner Basics • AP RADIUS authorization over Wireguard site2site tunnel
Hi guys.In the near future I will have to achieve a task with authorizing Wifi connections from remote location with RADIUS.Mikrotik AP_01 (10.20.200.150) is connected to Mikrotik gateway RTR_01...
View ArticleGeneral • Re: LHG 52 ac Wireless performance
When signal strength is too high, receiver gets overwhelmed and percieves increased noise level. Solution is to do something to decrease signal level to a bearable level, usually thats around -50dBm...
View ArticleUseful user articles • mDNS between VLANs with just bridge filters - no...
I had an issue on a site where I needed devices on VLAN2 to see Chromecasts, AppleTV's and Airprint on VLAN1. Taking some ideas I had while formulating the post about mDNS on Wireguard I tried it out....
View ArticleBeginner Basics • Re: DHCP/DNS configuration for two router setup
I think the easiest way is to remove the dhcp-server, the pool, the nat rule and the dhcp-client and just set the address to one from the desired subnet and add the 5G-WiFi link to the...
View ArticleBeginner Basics • Re: RouterOS 7.11.2 - "dns server failure" using...
For Me - I am the ISP...Turns out was agressive Firewall.Blocked input for UDP on all ppp interfaces, so looks like I did not have an "established/related" rule above... Was not trying from inside the...
View ArticleRouterBOARD hardware • Re: New hAP ax lite LTE
I'm a new to mikrotik world and I have just bought this new LTE router. So far so good. I would like to program the Mode button to switch on/off the wifi. Could someone post a script please with...
View ArticleBeginner Basics • Re: IPSEC IKEv2 cannot access LAN devices.
Could you please export configuration?Statistics: Posted by TheCat12 — Thu Feb 01, 2024 11:18 pm
View ArticleClik here to view.
Useful user articles • Re: mDNS between VLANs with just bridge filters - no...
Great work! Very Cleaver. You've been at this problem for a while now .Very minor nit on the example. The BridgemDNS is a "dumb" switch (e.g. vlan-filtering=no). And maybe the :export does this, but...
View ArticleWireless Networking • Re: Horribly slow Wi-Fi on Mikrotik network
I'm going to resurrect this thread due to something that's come to light whilst implementing a hAP ac2 at home discussed in detail in another thread. to recap - this particularly congested Wi-Fi...
View ArticleClik here to view.
General • OVPN Windows client disconnecting every 1 minute without internal...
Hi,Windows clients disconnecting every 60 seconds without internal tunnel traffic. The tunnel does not drop when there is internal traffic like icmp ping or any other and works great.I have mikrotik...
View ArticleWireless Networking • Re: missing roaming in wifiwave2 and signal strength
In wifiwave2 quite a bit of those requested parameters are not available (yet).Roaming only works within the same ROS instance.This means radios on the same AP, or radios controlled by the same...
View ArticleForwarding Protocols • Re: Splitting /24 between two BGP peers.
I still don't know how to do itStatistics: Posted by barcos — Fri Feb 02, 2024 1:34 am
View Article