Beginner Basics • Re: 2 WAN link and dst-nat configuration
Thank you very much!now, users can access server from both public IPs, but only there is another problemRDP works randomly, after every 3-4 times, users can not connect and should wait some seconds or...
View ArticleBeginner Basics • Two newbies getting super frustrated sxt lte
We have tried to various settings unplugging and rebooting going through the quick setup guides step by step and can't figure out why we don't have certain options or signal we set up an APN for...
View ArticleGeneral • Re: Problems with assign static IP to specific mac in mikrotik
Or reboot the client. Or disconnect the LAN cable to the client and then re-connect it. Or wait a while.Changing the IP to static or changing that IP address on the server does NOT force an immediate...
View ArticleContainers • proton bridge
not even sure if this is possibleanyone tried to get proton bridge running in a container, with a smtp relay so it's open to anything on the network (proton bridge explicitly listen on...
View ArticleBeginner Basics • Re: Transparent bridge, mangle and prerouting
Hi,My thought is that you might be better with a different router that has a different switch chip. (eg. A Hap AC^2)With these switch chips, you can set the bridge to be fully hardware forwarding,...
View ArticleBeginner Basics • Re: Help with configuration of a port.
Well Done :)Statistics: Posted by rplant — Thu Feb 29, 2024 7:08 am
View ArticleRouterBOARD hardware • New CRS326-24S+2Q+. Only two of three fans running....
As title says.Here is what I am looking at in SwOS:mik_fan.pngIs this normal behavior for this switch, or did I get a switch with a dead fan?I can confirm that I cannot feel any air flow from the...
View ArticleRouterBOARD hardware • Re: S-RJ01 SFP+ Modules Getting Stuck in Ports?
This issue is related to the design of the S-RJ01 module. We had to rip them out using force during our last migration, unfortunately in some cases damaging the switchport (or NIC) they were in.While...
View ArticleGeneral • Re: CRS305-1g-4s+ - issues on port mirror
Show the configuration from /interface/bridge and /interface/ethernet ... it's likely that your switch has HW offload enabled (otherwise it wouldn't be able to switch traffic at wirespeed) and port...
View ArticleGeneral • Re: L3HW traffic monitoring
There is no solution for this. L3HW offload implementation doesn't provide any detailed statistics, so if you need it, then ... well, you unfortunately can't use L3HW offload.Statistics: Posted by mkx...
View ArticleWireless Networking • Re: WIFI AP with WIFI Upstream
I'd suggest to go with dual-radio device (i.e. 2.4GHz + 5GHz bands).The reason is requirement for using WiFi as upstream. The problem is that when device uses same radio both in station mode (required...
View ArticleBeginner Basics • Re: WLAN to LAN connection in VLAN not possible
Hi,No one an Idea?Thank you very much in advance.RegardsThorstenStatistics: Posted by Thorsten1970 — Thu Feb 29, 2024 8:52 am
View ArticleRouterBOARD hardware • Re: CRS328-24P-4S+RM fan upgrade
I would have to install such devices in poorly ventilated and hot RACK cabinets ...I'm not sure if your plan is going to work in these conditions. The task of fans is to move ambient air efficiently...
View ArticleClik here to view.
Virtualization • CHR 7.14RC3/RC4 can't find network interface in Vultr
Hello everyone7.14rc3 Testing7.14rc4 TestingIn Vultrcan't find network interface in Vultr7.13.5 StableIn VultrFound the network interface. It's working.Is 7.14 removing some NIC drivers?Vultr...
View ArticleBeginner Basics • 2 gateway VPN need help.
Hi everyone, newbie here, so i want to create a vpn that incoming from ISP A and exit to ISP B, because for some reason ISP A cannot open certain web. and ISP B speed is very fast.so im imagine using...
View ArticleClik here to view.
Beginner Basics • Re: MikroTik | SXTR&FG621-EA LTE - no internet
Have also seen some ISP, don't want there customer use a router just use a modem.They check that with the ttl, so a workaround to that will be to mangle the ttl.Now you can press this bar to mark your...
View ArticleClik here to view.
Scripting • Re: Creating a script for sending SMS
WAN network is not blocked , but limited to 64kb, where mainly ping is working.I do not have script, but the above example is my starting point.I need somehow to refine it and make it working, but...
View ArticleClik here to view.
Beginner Basics • Re: Struggling with Pages Won't Redirect to Hotspot Login
Are you on CGNAT maybe ?So you don't get a usable public ip ?And can you describe a little more what you want to achieve?And in Mikrotik devices, the hotspot should only be reachable from the inside...
View ArticleBeginner Basics • Lot of packet retransmission with bonding (802.3ad) on...
I am currently working on setting up a 2 node-storages network with Mellanox 2x 10Gbit cards, connected through one mikrotik switch CRS326-24S+2Q+RM. I have configured bonding in mode 802.3ad with...
View ArticleGeneral • Some networks not accessible through L2TP Site-to-site VPN in...
Good day!I have a corporate network with main office and branch office. Network hardware vendor in Mikrotik. Recently I united networks with L2TP VPN. Now I have to pair two telephone iPECS stations...
View Article