Hey,
I had Router OS 7.12.1 running on a CRS326-24S+2Q+ and various VLANs configured in the Bridge config. Forwarding to the outgoing port was working fine until I upgraded to 7.14.1 yesterday. The issue is that I see traffic reaching the switch but the traffic isn't forwarded to the client port.
However, if I go into Bridge->VLAN config and disable/enable the VLAN entry it works again and the traffic is flowing again. So I would exclude a VLAN config issue.
If I stop traffic on the sender and restart after a few seconds I have to do the same again to make it work. If I don't toggle the VLAN I see traffic on the receiver for a quick moment, a few hundred packets maybe but then the switch stops forwarding. What issue can that be?
Thanks
Andre
I had Router OS 7.12.1 running on a CRS326-24S+2Q+ and various VLANs configured in the Bridge config. Forwarding to the outgoing port was working fine until I upgraded to 7.14.1 yesterday. The issue is that I see traffic reaching the switch but the traffic isn't forwarded to the client port.
However, if I go into Bridge->VLAN config and disable/enable the VLAN entry it works again and the traffic is flowing again. So I would exclude a VLAN config issue.
If I stop traffic on the sender and restart after a few seconds I have to do the same again to make it work. If I don't toggle the VLAN I see traffic on the receiver for a quick moment, a few hundred packets maybe but then the switch stops forwarding. What issue can that be?
Thanks
Andre
Statistics: Posted by andrep — Thu Mar 28, 2024 3:36 pm