[admin@MikroTik] > /system resource usb print
Columns: DEVICE, VENDOR, NAME, SPEED
# DEVICE VENDOR NAME SPEED
0 1-0 Linux 5.6.3 ehci_hcd RB400 EHCI 480
1 1-1 American Power Conversion Smart-UPS 750 FW:651.12.I USB FW:4.2 1.5
[admin@MikroTik] > /port print
Columns: NAME, CHANNELS, USED-BY, BAUD-RATE
# NAME CHANNELS USED-BY BAUD-RATE
0 serial0 1 Serial Console 2400
[admin@MikroTik] > /system ups add port=serial0 # if I press [Tab], only serial0 is suggested
[admin@MikroTik] > /system ups add port=usb0
input does not match any value of port
[admin@MikroTik] > /system ups add port=usb1
input does not match any value of port
[admin@MikroTik] > /system ups add port=usb2
input does not match any value of port
[admin@MikroTik] > /system ups add port=usb1-1
input does not match any value of port
Is there something I missed to configure?
First, it was necessary to release the serial0 port from the console...
Statistics: Posted by Sertik — Wed Mar 20, 2024 4:32 pm