Hello!
I have a capsman network at home using 4 CAP ac (RBcAPGi-5acD2nD)
I have a lot of overlap and I believe that reducing the tx power would improve the device roaming between the caps.
I took a look on the Wiki, and I couldn't find a proper value to use, actually, there was a lot of warnings regarding the risks of damaging the radio interface.
https://wiki.mikrotik.com/wiki/Manual:W ... _can_I_use?
I saw someone suggesting, to use the value "10", I tried this (Capsman > Channels > Channel tx power), and I'm not sure if its coincidence or not but the device distribution between caps now looks a lot better. Most devices are pretty close to the caps, but now I went back to the default until I have this information clear.
What would be a good tx power value for a cap in the same room of the devices?
Can someone please confirm whats is the tx power that this hardware supports? (Also whats the txpower allowed for Brazil)?
Thank you!
I have a capsman network at home using 4 CAP ac (RBcAPGi-5acD2nD)
I have a lot of overlap and I believe that reducing the tx power would improve the device roaming between the caps.
I took a look on the Wiki, and I couldn't find a proper value to use, actually, there was a lot of warnings regarding the risks of damaging the radio interface.
https://wiki.mikrotik.com/wiki/Manual:W ... _can_I_use?
I saw someone suggesting, to use the value "10", I tried this (Capsman > Channels > Channel tx power), and I'm not sure if its coincidence or not but the device distribution between caps now looks a lot better. Most devices are pretty close to the caps, but now I went back to the default until I have this information clear.
What would be a good tx power value for a cap in the same room of the devices?
Can someone please confirm whats is the tx power that this hardware supports? (Also whats the txpower allowed for Brazil)?
Thank you!
Statistics: Posted by eduardosilva — Thu Mar 14, 2024 5:37 pm