General • WireGuard Handshake

Oddly enough WireGuard works inside my network, but, fails to connect externally. Any suggestions are greatly appreciated.

[wg0] Starting WireGuard/0.5.3 (Windows 10.0.19045; amd64)
[wg0] Watching network interfaces
[wg0] Resolving DNS names
[wg0] Creating network adapter
[wg0] Installing driver 0.10
[wg0] Extracting driver
[wg0] Installing driver
[wg0] Creating adapter
[wg0] Using WireGuardNT/0.10
[wg0] Enabling firewall rules
[wg0] Interface created
[wg0] Dropping privileges
[wg0] Setting interface configuration
[wg0] Peer 1 created
[wg0] Monitoring MTU of default v4 routes
[wg0] Sending keepalive packet to peer 1 (x.x.x.x:13231)
[wg0] Sending handshake initiation to peer 1 (x.x.x.x:13231)
[wg0] Interface up
[wg0] Setting device v4 addresses
[wg0] Monitoring MTU of default v6 routes
[wg0] Setting device v6 addresses
[wg0] Startup complete
[wg0] Handshake for peer 1 (x.x.x.x:13231) did not complete after 5 seconds, retrying (try 2)
[wg0] Sending handshake initiation to peer 1 (x.x.x.x:13231)

Statistics: Posted by mcponcall — Wed Mar 13, 2024 3:11 pm

---