Quantcast
Channel: MikroTik
Viewing all articles
Browse latest Browse all 15394

Beginner Basics • Re: hap ax2 config copied to hap ax3?

$
0
0
To sum it up:
2.4 GHz sucks (because it is slow and - in densely populated areas - polluted by countless conflicting radios).
5 GHz sucks even more because it won't go through walls (or any other thing thicker than a sheet of paper) and let's not forget the real or fake radar interferences, 10 minutes cac's, etc., so it will work (fast enough) or not work.

A candle (in the wind) vs. a blinking light, compare with the light of the sun (a good ethernet cabled connection).

Since you are Italian, "Se sei bello ti tirano le pietre, se sei brutto ti tirano le pletre". (for non-italian readers, this was an old song, translatable to "they throw stones at you, no matter if you are ugly or beautiful").
did some more testing in the room behind where the AX2 is sitting seemed to get full signal on both 2GHZ and 5 GHZright now 2 GHZ is pushing about 150 MB 5 GHZ is pushing 350 MB

Statistics: Posted by antoniocerasuolo — Tue Feb 06, 2024 9:57 pm



Viewing all articles
Browse latest Browse all 15394

Trending Articles