I tried your tip (set detect-interface-list=none) but it did not let all equipment run in the same domain. Are you sure this command changes the behavior? To me it seems to be a filter for reporting purposes, not something that changes the state of an interface.
I am surprised my requirement seems to be so complicated. If I could use a CAT-cable from router-1 to router-2 I would have replaced router-2 with a cheap and simple non-managed switch. One end of the cable into router-1 and the other end into the switch. My equipment on the switch side is all wired and would also be plugged into the switch to make it work. Now I replace my CAT-cable with a wifi-connection and all simplicity is gone
I am surprised my requirement seems to be so complicated. If I could use a CAT-cable from router-1 to router-2 I would have replaced router-2 with a cheap and simple non-managed switch. One end of the cable into router-1 and the other end into the switch. My equipment on the switch side is all wired and would also be plugged into the switch to make it work. Now I replace my CAT-cable with a wifi-connection and all simplicity is gone
Statistics: Posted by LukeS — Sun Feb 04, 2024 5:52 pm