General • To xSTP...or not

I red a lot about using Spanning Tree Protocol and found that it is recommended to use RSTP when using hAP ax2 and hAP ax3.

If the CAP is hAP ax2 or hAP ax3, it is strongly recommended to enable RSTP in the bridge configuration, on the CAP

configuration.manager should only be set on the CAP device itself, don't pass it to the CAP or configuration profile that you provision.

I'm running a network which is shown in the image below, and am using a total of 5 VLAN's.

My question, should I enable xSTP? And should it be MSTP due to the different VLAN's? Or RSTP? Or can I leave it to None?
For your information, all CAP's, controlled by the RB4011, are using the new wifi-qcom-ac driver.

Statistics: Posted by erlinden — Mon Jan 29, 2024 9:57 pm

---